Check the index of the address pool bound to the interface.
<Huawei> display nat outbound
NAT Outbound Information:
--------------------------------------------------------------------------
Interface Acl Address-group/IP/Interface Type
--------------------------------------------------------------------------
GigabitEthernet0/0/0 2000 1.1.1.1 easyip
GigabitEthernet0/0/1 3000 1 pat
--------------------------------------------------------------------------
Total : 2
For PAT mode, check IP addresses bound to the address pool based on the address pool index.
<Huawei> display nat address-group 1
NAT Address-Group Information:
--------------------------------------
Index Start-address End-address
--------------------------------------
1 110.0.0.100 110.0.0.110
--------------------------------------
Total : 1
For Easy IP mode, run the display nat outbound command on the router to view Easy IP information configured on the NAT outbound interface.
<Huawei> display nat outbound
NAT Outbound Information:
--------------------------------------------------------------------------
Interface Acl Address-group/IP/Interface Type
--------------------------------------------------------------------------
GigabitEthernet0/0/0 2000 1.1.1.1 easyip
GigabitEthernet0/0/1 3000 1 pat
--------------------------------------------------------------------------
Total : 2
Run the ping command with the source IP address specified to check whether the public IP address can be pinged. For example, use the ping -a x.x.x.x y.y.y.y, where x.x.x.x indicates the IP address of the WAN interface or NAT address pool, and y.y.y.y indicates the WAN-side gateway address. The IP address that fails to be pinged cannot be used for NAT. For the cause of the ping failure, contact the ISP.